Series 1000-2000 Wall Mount

The Series 1000-2000 Fuel Gas Sensors are intended for use with an ISIMET Controller System where fuel gas is controlled.  The sensor derives power directly from the controller and transmits a dry-contact or 24VAC signal back to the controller when raw fuel gas is detected, thereby shutting down the gas flow.

A flashing beacon located on the wall plate will notify the user that raw gas has been detected.  Once the delay time expires, a signal is transmitted to the Controller.  Applying the signal to the Controller will turn OFF the gas circuit, as well as any other circuit that has selected programming to monitor for raw fuel gas detection.  The beacon will then remain ON continually until the sensor has been reset.  The sensitivity of the sensor is preset at the factory to 500ppm but may be adjusted up to 100,000ppm.

Time delay feature optional pre-set @ 0, 10, 20 or 30 seconds to allow for a momentary delay in notification when raw gas is detected, enabling the user to turn OFF a fuel gas outlet before a notification signal has been sent.

Reset of the unit will only occur once no raw gas is detected.  Reset is accomplished by Re-keying the Utility Controller to which it is connected (Series 1000 Only), or by the panel mounted reset switch.  Reset by Re-keying the controller will also turn back ON all utilities disabled by the sensor that have their service switch in the ON position.


     

     

    Series 1000-2000 Wall Mount Specifications:

    Mounting Style 1 Wall Panel – Stainless Steel 16 gauge (5.75” X 5.75”)

    Mounting Style 3 Wall Panel – Stainless Steel 16 gauge (5” X 5”)

    *Hex Key screws secure panel to enclosure

    Mounting Style 1 Wall Box Enclosure – 16 gauge powder coated sheet metal (5 X 5 X 3)

    Mounting Style 3 Wall Box Enclosure – Optional 16 gauge Stainless Steel (5 X 5 X 3)